Suspension Control Module: Service and Repair

Air Suspension Module





Removal and Installation

WARNING: Before carrying out maintenance on any air suspension components, disconnect the power to the system by turning off the air suspension switch located on the LH side of the luggage compartment to prevent vehicle damage. Failure to follow these instructions may result in personal injury.

CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage can result.

CAUTION: Suspension fasteners are critical parts because they effect performance of vital components and systems and their failure can result in major service expense. A new part with the same part number or an equivalent part must be installed, if installation is necessary. Do not use a part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.

1. Turn the air suspension service switch to the OFF position.
2. Disconnect the battery ground cable.
3. While pushing in on the 2 glove compartment door tabs, position the glove compartment downward.
4. Remove the air suspension module.
1 Disconnect the electrical connectors.
2 Disconnect the module from the bracket.
3 Remove the air suspension module.
5. To install, reverse the removal procedure.