Engine Mount - LH

Engine Mount - LH

Special Tool(s):

Material:

Removal and Installation

1. WARNING: If equipped with fire suppression system, depower the system. For important safety warnings and procedures, refer to Fire Suppression System.

With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the generator.
3. Install the special tool.





4. Install the special tool.





5. Remove the oil filter and discard.
^ Lubricate the new oil filter O-ring seal with clean engine oil prior to installation.

6. NOTE: LH shown, RH similar.

Remove the LH and RH lower engine mount nuts.
^ To install, tighten to 90 Nm (66 ft. lbs.).
7. Using the special tool, raise the engine.





8. Remove the 3 LH engine mount bolts.
^ To install, tighten to 70 Nm (52 ft. lbs.).
9. Remove the LH engine mount.

10. WARNING: If equipped with fire suppression system, repower the system. For important safety warnings and procedures, refer to Fire Suppression System.

To install, reverse the removal procedure. If equipped with fire suppression system, repower the system.