Shifter M/T: Service and Repair

Gearshift Lever

Gearshift Lever:

Removal
1. Remove the gearshift knob.
2. Remove the floor console finish panel.

3. CAUTION: Carefully disconnect the cable from the shift lever. Do not damage the shift cable retainers.





Disconnect the gearshift cables from the gearshift lever.
4. Remove the 2 front console center bolts.
5. Remove the 4 gearshift lever nuts.
6. Remove the gearshift lever assembly.

Installation
1. Position the gearshift lever assembly in the vehicle.
2. Install the 4 gearshift lever nuts.
^ Tighten to 23 Nm (17 ft. lbs.).
3. Connect the selector cable.
4. Connect the shift cable.
5. Install the 2 front console center bolts.
6. Adjust the gearshift cables.
7. Install the floor console finish panel.
8. Install the gearshift knob.