Test K: The Temperature Control Is Inoperative/Does Not Operate Correctly

PINPOINT TEST K: THE TEMPERATURE CONTROL IS INOPERATIVE/DOES NOT OPERATE CORRECTLY

K1-K2:

K2-K3:

K4-K5:

K6-K8:

K8-K10:

K10-K12:

K12-K13:

K13-K14:

K14-K15:

K15-K16:

K16-K17:

K17-K18:

K18 Continued:

Normal Operation
Under normal operation, to rotate the blend door actuator, the EMTC module or EATC module supplies voltage to the blend door actuator motors through the door actuator feed A circuits, and supplies ground through the door actuator feed B circuits. To reverse the blend door actuator rotation, the EMTC module or EATC module reverses the voltage and ground circuits.

The blend door actuator feedback resistors are supplied a ground from the EMTC module or EATC module by the blend door actuator return circuits and a 5-volt reference voltage on the blend door actuator reference circuits. The EMTC module or EATC module reads the voltage on the blend door actuator feedback circuits to determine the blend door actuator position, by the position of the actuator feedback resistor wiper arm.

Door actuator feed A circuits
- (EATC) LH Blend - CH238 (YE/OG)
- (EMTC) LH Blend - CH233 (VT/BN)
- RH Blend - CH212 (BU/OG)

Door actuator feed B circuits
- (EATC) LH Blend - CH239 (BU/WH)
- (EMTC) LH Blend - CH234 (YE/GN)
- RH Blend - CH213 (BN/GN)

Door actuator return circuits
- LH Blend - RH111 (GY/BU)
- RH Blend - RH111 (GY/BU)

Door actuator reference circuits
- LH Blend - LH111 (BN/WH)
- RH Blend - LH111 (BN/WH)

Door actuator feedback circuits
- (EATC) LH Blend - VH440 (BN/BU)
- (EMTC) LH Blend - VH439 (GY/VT)
- RH Blend - VH441 (WH/BN)

Possible Causes
- An open, short to voltage, ground or together in door actuator open, close, return, reference or feedback circuits
- Blend door actuator motor
- EATC module
- EMTC module
- Stuck or bound linkage or door