Safety Belt With Anchor Plate Thread Damage
SAFETY BELT WITH ANCHOR PLATE THREAD DAMAGE1. NOTE: The lap/shoulder safety belts are factory-installed in their correct locations. If the safety belts are removed for any reason, they must be installed. The anchor bolts must be hand-started and then tightened to the correct torque specifications as noted in the Torque Specifications table.
Remove the broken or stripped bolt.
2. Drill out the internal threads in the safety belt anchor plate with a 27/64 inch drill bit.
3. Rethread the anchor plate with a 1/2-13 tap.
4. Blow out the chips.
5. Install the attachment parts in the correct sequence. Install a new bolt. Hand-tighten and then tighten to correct torque specifications as noted in the Torque Specifications table.