Brake Caliper Anchor Plate, Rear

Brake Caliper Anchor Plate

Removal and Installation

Disc Brake System - Exploded View:

1. WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension vehicle. This can be accomplished by turning off the air suspension service switch. Failure to do so can result in unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle during these operations. Failure to follow these instructions may result in personal injury.

If equipped, turn the air suspension service switch to the OFF position.

2. WARNING: If equipped with fire suppression system, depower the system. For important safety warnings and procedures, refer to Fire Suppression System.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
3. Disconnect the rear parking brake cable and conduit.
4. Remove the axle shaft.

5. WARNING: To avoid injury when using air tools, do not hold flagnuts with fingers. Failure to follow these instructions may result in personal injury.

Remove the 4 retainers and the brake caliper anchor plate.
^ To install, tighten to 68 Nm (50 ft. lbs.).

6. WARNING: If equipped with fire suppression system, repower the system. For important safety warnings and procedures, refer to Fire Suppression System.

If equipped with fire suppression system, repower the system.
7. To install, reverse the removal procedure.
8. If equipped, turn the air suspension service switch to the ON position.