Transmission Position Sensor/Switch: Service and Repair

Digital Transmission Range (TR) Sensor

Special Tool(s):

Removal
1. WARNING: If equipped with fire suppression system, depower the system. For important safety warnings and procedures, refer to Fire Suppression System.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.





2. Disconnect the manual lever shift control cable.





3. Disconnect the digital transmission range (TR) sensor connector.





4. Remove the bolts and remove the digital TR sensor.

Installation





1. Install the digital TR sensor and loosely install the bolts.





2. NOTE: Manual shift lever shaft must be in the neutral position.

Using the special tool, align the digital TR sensor slots. The tool is designed to fit snugly.





3. CAUTION: Tightening one screw before tightening the other may cause the sensor to bind or become damaged.

Tighten the screws in an alternating sequence.
^ Tighten to 9 Nm (80 inch lbs.).





4. With the manual lever in overdrive, connect the shift lever control cable.
^ Tighten to 23 Nm (17 ft. lbs.).





5. Connect the digital TR sensor electrical connector.

6. WARNING: If equipped with fire suppression system, repower the system. For important safety warnings and procedures, refer to Fire Suppression System.

If equipped with fire suppression system, repower the system.