Roof Opening Panel

ROOF OPENING PANEL

Removal
1. Remove the headliner.
2. Disconnect the 2 front and 2 rear drain hoses.
3. Disconnect the roof opening panel motor electrical connector.
4. Position the roof opening panel motor wiring harness aside.
- Remove the tie strap.
- Release the 5 wiring harness retaining clips.

5. CAUTION: Support the roof opening panel to prevent the unit from dropping.

Remove the 6 roof opening panel frame bolts.

6. Remove the 2 roof opening panel support strap bolts.
7. Remove the roof opening panel.

Installation

1. NOTE: Make sure the roof opening panel motor wiring harness is not pinched by the roof opening panel frame.

Position the roof opening panel to the vehicle.







2. Install the 6 roof opening panel frame bolts and tighten in the sequence shown.
- Tighten to 10 Nm (89 lb-in).

3. Install the 2 roof opening panel support strap bolts.
- Tighten to 10 Nm (89 lb-in).

4. Connect the roof opening panel motor electrical connector.
5. Position the roof opening panel motor wiring harness.
- Attach the 5 wiring harness retaining clips.
- Install the tie strap.

6. Connect the 2 front and 2 rear drain hoses.
7. Install the headliner.
8. Align the roof opening panel glass.
9. Initialize the roof opening panel motor.