Fuel Pressure Sensor/Switch: Service and Repair
FUEL INJECTION PRESSURE AND TEMPERATURE SENSORRemoval and Installation
1. Release the fuel system pressure.
2. Disconnect the battery ground cable.
3. NOTE: 4V shown, 2V similar.
Disconnect the fuel injection pressure and temperature sensor electrical connector and the vacuum hose.
4. Remove the bolts and the fuel injection pressure and temperature sensor.
5. NOTE:
- Before installing the fuel injection pressure and temperature sensor, inspect and lubricate the O-ring seal with clean engine oil.
- Hand-tighten both bolts before tightening to specification.
To install, reverse the removal procedure.