Instrument Cluster (IC)

INSTRUMENT CLUSTER

Removal and Installation

NOTE: When installing a new instrument cluster, it is necessary to upload the module configuration to the diagnostic tool. Following installation of the instrument cluster, download the module configuration from the diagnostic tool into the new instrument cluster.

1. Depower the supplemental restraint system (SRS).
2. Remove the instrument cluster finish panel.







3. Remove the transmission range selector lever cable, if equipped with column-shift.
1 Remove the screw.
2 Disconnect the cable.







4. Remove the instrument cluster.
- Remove the screws.
- Disconnect the electrical connector.

5. To install, reverse the removal procedure.