Headliner: Service and Repair

HEADLINER







Removal and Installation
1. For vehicles not equipped with side safety curtains, depower the SRS.
2. Remove the LH and RH A-pillar trim panels.
- Pull the top of the A-pillar trim panel toward the inside of the vehicle.
- Pull the A-pillar trim panel upward to remove from the dash panel.

3. Remove the driver side front seat.
4. Remove the front floor console.
5. Remove the LH and RH B-pillar trim panels.
6. Remove the LH and RH C-pillar trim panels.
7. Remove the 3 handle assemblies from the headliner.
- Disconnect the handle assembly screw covers.
- Remove the handle assembly screws.

8. Remove the LH and RH sun visor assemblies.
- Remove the 3 sun visor retaining screws.
- Disconnect the sun visor wire harness electrical connector.
- Remove the sun visor arm clip screw.
- Remove the sun visor arm clip.

9. Remove the overhead console.
- Pull the overhead console downward to release the retaining clips.
- Disconnect the overhead console electrical connector.

10. If equipped, disconnect the roof opening panel electrical connector.
11. If equipped, disconnect the auto-dimming electrical connector from the interior rear view mirror.
12. If equipped, disconnect the compass sensor electrical connector from the compass sensor.
13. Disconnect the electrical connector located on the A-pillar.
- Disconnect the wiring harness tree-clips located on the A-pillar.

14. If equipped, disconnect the safety canopy bridge resistor electrical connector.
15. Remove the 3 trim panel retaining clips from the rear of the headliner.
16. Position the right side front seat rearward and recline.
17. Remove the headliner.
- Lower the headliner.
- Remove the headliner through the right front door opening.

18. To install, reverse the removal procedure.