Throttle Body: Service and Repair

THROTTLE BODY







Removal and Installation
1. Remove the air cleaner outlet pipe.
2. Disconnect the electronic throttle body coolant feed and return hoses.
1 Disconnect the coolant hoses.
2 Plug the coolant hoses.

3. Disconnect the electronic throttle body electrical connector.
4. Remove the bolts and the throttle body.
- To install, tighten to 10 Nm (89 lb-in).

5. NOTE: Gasket is press-in-place in manifold.

Remove and discard the throttle body gasket.

6. Clean and inspect the sealing surfaces.
7. To install, reverse the removal procedure.
- Install a new throttle body gasket.