Crankshaft, Engine

Crankshaft
Main bearing journal diameter 62.968 - 62.992 mm (2.479 - 2.480 inch)
Main bearing journal maximum taper 0.008 mm (0.0003 inch)
Main bearing journal maximum out-of-round 0.006 mm (0.0082 inch)
Main bearing journal-to-cylinder block clearance 0.024 - 0.072 mm (0.0009 - 0.003 inch)
Connecting rod journal diameter 49.969 - 49.991 mm (1.967 - 1.968 inch)
Connecting rod journal maximum taper 0.008 mm (0.0003 inch)
Connecting rod journal maximum out-of-round 0.006 mm (0.0002 inch)
Crankshaft maximum end play 0.135 - 0.255 mm (0.005 - 0.010 inch)





Position the lower cylinder block and install the bolts and studs.

Tighten the bolts and studs in the sequence shown in four stages.
Stage 1: Tighten fasteners 1-8 to 25 Nm (18 ft. lbs.).
Stage 2: Tighten fasteners 9-16 to 40 Nm (30 ft. lbs.).
Stage 3: Tighten fasteners 1-16 90 degrees.
Stage 4: Tighten fasteners 17-22 to 25 Nm (18 ft. lbs.).