Monitors, Trips, Drive Cycles and Readiness Codes

Transmission Drive Cycle Test

NOTE: Always drive the vehicle in a safe manner according to driving conditions and obey all traffic laws.

NOTE: The Transmission Drive Cycle Test must be followed exactly. Malfunctions must occur four times consecutively for shift error DTC code to be set, and five times consecutively for continuous TCC code to set.

NOTE: When carrying out the Transmission Drive Cycle Test, refer to the Solenoid Application Chart for correct solenoid operation.

After carrying out the Quick Test, use the Transmission Drive Cycle Test for checking continuous codes.
1. Record and then erase Quick Test codes.
2. Warm engine to normal operating temperature.
3. Make sure transmission fluid level is correct.
4. With transmission in OVERDRIVE, moderately accelerate from stop to 80 km h (50 mph). This allows the transmission to shift into fourth gear. Hold speed and throttle open steady for a minimum of 15 seconds.
5. With transmission in fourth gear and maintaining steady speed and throttle opening, lightly apply and release brake to operate stoplamps. Then hold speed and throttle steady for a minimum of five seconds.
6. Brake to a stop and remain stopped for a minimum of 20 seconds.
7. Repeat steps 4 through 6 at least five times.
8. Carry out Quick Test and record continuous DTCs.
^ If the DTCs are still present, refer to the Diagnostic Trouble Code Chart. Repair all non transmission DTCs first as they can directly affect the operation of the transmission. Repeat the Quick Test and the Road Test to verify the correction. Erase the DTCs, carry out the Drive Cycle Test and repeat the Quick Test after completing repair on the DTC.
^ If the continuous test passes and a concern is still present, refer to Diagnosis By Symptom, OASIS messages, and TSBs for concerns. Check TSBs and Oasis

After On-Board Diagnostic

NOTE: The vehicle wiring harness PCM and non-transmission sensors may affect transmission operations. Repair these concerns first.

After the on-board diagnostic procedures are completed repair all DTCs.

Begin with non-transmission related DTCs then repair any transmission-related DTCs. Use the DTC Chart for information on condition and symptoms. This chart will be helpful in referring to the correct manual(s) and aids in diagnosing internal transmission concerns and external non-transmission inputs. The pinpoint tests are used in diagnosing transmission electrical concerns. Make sure that the vehicle wiring harness and the PCM are diagnosed as well. The Powertrain Control/Emissions Diagnosis (PC/ED) manual will aid in diagnosing non-transmission electronic components.

Before Pinpoint Tests

NOTE: Prior to entering pinpoint tests check the PCM wiring harness for tight connections bent or broken pins corrosion loose wires correct routing correct seals and their condition. Check the PCM sensors and actuators for damage.

NOTE: If a concern still exists after electrical diagnosis has been carried out refer to Diagnosis By Symptom.

If DTCs appear while carrying out the on-board diagnostics refer to the Diagnostic Trouble Code (DTC) Charts for the appropriate repair procedure. Prior to entering pinpoint tests refer to any TSB messages for transmission concerns.