Vehicle Damage Warnings

CAUTION:
^ Make sure the horn wiring is routed out between the air bag backing plate and the steering wheel. Failure to do so may result in the air bag not deploying correctly.
^ Do not deactivate the side air bag module circuit by removing the side air bag bridge resistor from the side air bag floor electrical connector. Refer to Air Bag(s) Arming and Disarming.
^ Use care when separating the seat back trim cover from the hook and loop strip, or the hook and loop strip could be torn from the seat back foam.
^ Stainless steel hog rings need to be used on seats with side air bag modules. This will ensure correct deployment of the side air bag.