Driven Sprocket Support/Check

Driven Sprocket Support

Part 1 Of 2:

Part 2 Of 2:

Special Tool(s)

Disassembly





1. Remove the Teflon seal rings and the No. 5 thrust washer.





2. Using the special tools, remove the bearing.

Assembly





1. If removed, install a new driven sprocket bearing. Using an arbor press and the special tools, install a new driven sprocket bearing.





2. CAUTION: The seal rings must be installed correctly. Transaxle failure could result.

Install new Teflon seals and the No. 5 thrust washer.





3. Make sure that the seals are mated correctly.

Driven Sprocket

Check





1. Check the bearing race to verify that it has not moved out of position or become scored. If worn or scored, install a new driven sprocket.
Inspect the sensor wheel for bent or damaged tabs.





2. NOTE: If damaged, install a new speed sensor wheel.

Remove the speed sensor wheel.





3. Install new speed sensor ring.