Crankshaft, Engine

Crankshaft
Main bearing journal
Diameter 67.483 - 67.503 mm (2.6568 - 2.6576 in.)
Maximum taper 0.004 mm (0.0002 in.)
Maximum out-of-round 0.0075 mm (0.0003 in.) between cross sections
Main bearing journal-to-cylinder block clearance 0.066 - 0.024 mm (0.0259 - 0.0009 in.)
Connecting rod journal
Diameter 53.003 - 52.983 mm (2.0867 - 2.0859 in.)
Maximum taper (straightness) 0.004 mm (0.0002 in.)
Maximum out-of-round 0.0075 mm (0.0003 in.) between cross sections
Crankshaft maximum end play 0.301 mm (0.0118 in.)





Back out the jack screws against the cylinder block.
Stage 1: Tighten to 5 Nm (44 in. lbs.)
Stage 2: Tighten to 10 Nm (89 in. lbs.)





Tighten jack screws
Stage 1: Tighten to 10 Nm (89 in. lbs.)
Stage 2: Tighten to 21 Nm (15 ft. lbs.)





Main bearing cap bolts.
Stage 1: Tighten to 40 Nm (30 ft. lbs.)
Stage 2: Tighten an additional 90 degrees