Turn Signal Switch: Service and Repair

Steering Column Multifunction Switch

Removal and Installation

1. Disconnect the battery ground cable.





2. Remove the ignition switch lock cylinder.
1 Insert the ignition key into the ignition switch lock cylinder and turn to the RUN position.
2 Push the ignition switch lock cylinder release tab with a punch while pulling out the ignition switch lock cylinder.





3. Remove the tilt wheel handle and shank.





4. Remove the upper and lower steering column shrouds.
^ Remove the screws.





5. Remove the multifunction switch.
1 Remove the screws.
2 Disconnect the electrical connectors.
6. To install, reverse the removal procedure.