Sensor, Rear

Rear Wheel Speed Sensor

Removal and Installation
1. Remove rear seat bottom.





2. Disconnect the rear anti-lock brake sensor electrical connector.





3. Push the sensor harness grommet through the passenger compartment floor.

4. WARNING: The electrical power to the air suspension system must be turned off prior to hoisting, jacking or towing an air suspension vehicle. Failure to do so can result in unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle during these operations.

Raise and support the vehicle.





5. Disconnect the routing clips.





6. Remove the rear anti-lock brake sensor.
1 Remove the bolt.
2 Remove the sensor.
7. To install, reverse the removal procedure.