Vehicle Damage Warnings

CAUTION:
^ If replacing only the front passenger seat cushion trim cover, the seat occupant classification sensor must be rezeroed.
^ Do not deactivate the side air bag module circuit by removing the side air bag bridge resistor from the side air bag floor connector. If the side air bag resistor is removed, an open circuit fault will be generated by the restraint control module (RCM).

If a restraint system diagnostic tool is installed at the side air bag floor connector, a low resistance fault will be generated by the RCM.
^ Installing a J-nut in place of a weld nut is not a recommended repair.
^ The clockspring electrical connectors are unique and cannot be reversed when connected to the driver air bag module. Match the electrical connector key to the keyway in the driver air bag module. Do not force the electrical connectors into the driver air bag module.