Initial Inspection and Diagnostic Overview
Special Tool(s)Special Tools:
Inspection and Verification:
WARNING: Use of any other than the approved DOT 3 or DOT 4 brake fluid will cause permanent damage to brake components and will render the brakes inoperative.
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink water and induce vomiting. Get medical attention immediately.
CAUTION: Do not spill brake fluid onto painted surfaces. If spilled, wipe up immediately.
NOTE: Always check the fluid level in the brake master cylinder reservoir before performing the test procedures. If the fluid level is not at the correct level, clean the brake reservoir filler cap before removing, and add DOT 3 brake fluid. If DOT 3 is not available use DOT 4 brake fluid
NOTE: Prior to carrying out any diagnosis, make sure the brake warning indicator is functional.
The first indication that something may be wrong in the brake system is a change in the feeling through the brake pedal. The brake warning indicator in the instrument cluster and the brake fluid level in the brake master cylinder reservoir are also indicators of system concerns.
If a wheel is locked and the vehicle must be moved, open a bleeder screw at the locked wheel to let out enough fluid to relieve the pressure. Close the bleeder screw. This bleeding operation may release the brakes but will not correct the cause of trouble. If this does not relieve the locked wheel condition repair the locked components before proceeding.
Inspect all hoses and connections. All unused vacuum connectors should be capped. Make sure hoses and their connections are correctly secured and in good condition with no holes, soft or collapsed areas.
Non-Pressure Leaks
The only part of the brake system that could have a brake fluid loss that does not appear when the system is under pressure is the brake master cylinder reservoir area. Brake fluid loss can be caused by a missing or poorly-fitted brake master cylinder filler cap, a punctured or otherwise damaged brake master cylinder reservoir, a missing or damaged brake master cylinder filler cap gasket, or by missing, damaged or poorly-fitted sealing grommets between the brake master cylinder and the brake master cylinder reservoir.
The brake master cylinder reservoir grommets are not separately serviceable and must be installed new as part of a new brake master cylinder reservoir.
Install a new flexible brake hose if it shows signs of softening, cracking or other damage.
When installing a new brake hose, position the hose to avoid contact with other vehicle components.
Road Test
If a road test is carried out, select a road that is reasonably smooth and level. Gravel or bumpy roads are not suitable because the surface does not allow the tires to grip the road equally. Avoid crowned roads.
A key factor in evaluating brake concerns is the deceleration rate. This varies from vehicle to vehicle and with changes in operating conditions. It is evident how well the brakes are working after just a few applications.
Avoid locking the brakes. Locked brakes are not an indication of braking efficiency.
Visual Inspection Chart
For low or spongy brake pedal concerns:
^ Check and, if necessary, refill the brake master cylinder reservoir.
^ Bleed the brake system and retest the brake pedal feel.
^ If the brake pedal is still low or feels spongy, check the brake pedal mounting for looseness and correct installation. Check the power brake booster and the brake master cylinder for loose mounting. Correct as necessary and retest the system for normal operation.
For a slow or incomplete brake pedal return concern:
^ Inspect for binding, damage, correct installation or interference at the brake pedal.
^ Check the power brake booster for binding, damage and correct installation.
For excessive or erratic brake pedal travel concerns:
^ Check for spongy pedal and bleed as necessary.
^ Check the brake pedal mounting for wear, damage, binding and correct installation.
^ Check the disc brake caliper components for wear, damage, binding and correct installation.
^ Check the power brake booster, and brake master cylinder for damage and correct installation.
^ Check wheel bearings and rear axle end play. Correct as necessary.