Parking Brake Cable: Adjustments
Parking Brake Cable Adjustment1. Release the parking brake control, using the parking brake release handle.
2. WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension vehicle. This can be accomplished by turning off the air suspension switch located in the luggage compartment. Failure to do so can result in unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle during these operations.
Raise and support the vehicle.
3. Pull the parking brake cable adjuster clip downward. The tensioner spring will take up the cable slack and preload the cables
4. Push up on the bottom of the clip to lock the adjustment. If the clip does not slide up, move the assembly slightly to align the closest groove on the parking brake cable adjuster rod with the clip.
5. NOTE: If new cables are installed, allow 20 minutes prior to releasing the parking brake control.
Apply the parking brake control fully and release using the parking brake release handle.
6. Repeat Step 3 and Step 4 to complete the adjustment procedure.