LH

Valve Cover-LH

Removal and Installation
1. Raise and support the vehicle.





2. Disconnect the oil pressure sensor electrical connector, the power steering pressure sensor electrical connector and the harness position retainer.
3. Lower the vehicle.





4. Disconnect the cylinder head temperature (CHT) sensor jumper wire connector.





5. Remove the bolt and the two studs and position the bracket out of the way.





6. Disconnect the camshaft position (CMP) sensor electrical connector.





7. Disconnect the fuel charging wiring electrical connectors from the coils and the fuel injectors.
8. Remove the wiper and cowl.





9. Disconnect the:
- 42-pin connector.
- 16-pin connector.
- transmission electrical connector.





10. Remove the six bolts and five studs and remove the valve cover.





11. To install, reverse the removal procedure.
- Apply sealant in the locations shown.





12. Tighten the bolts and studs in the sequence shown.