Rear Door Window Glass: Service and Repair

Heavy Duty Riveter:

SPECIAL TOOL(S)

REMOVAL
1. Remove the rear door trim panel.







2. Remove the pull strap handle.
3. Remove the water shield.
^ Mark the water shield and inner door to indicate the original position.

NOTE: The water shield must be installed in the original position.







4. Remove the inner belt line moulding.







5. Remove the outer belt line moulding.







6. Remove the front door glass top run bolt.







7. Remove the rivets.

CAUTION: Do not attempt to forcibly remove the rivets as damage to the rear door window glass may result. Prior to removing the rivet center pins, it is necessary to place a suitable block support between the door outer panel and the rear door window channel bracket to stabilize the rear door window glass during rivet removal.







8. Remove the rear door glass top run bolt.







9. Remove the rear door window glass.

INSTALLATION

















1. To install, reverse the removal procedure.
^ Using the special tool, install two spacers and two 1/4-inch rivets (use of 1/4 - 20 x 1 inch screw and washer assemblies and 1/4 inch - 20 nut and washer are optional). Tighten the nut (if used) to 13 Nm (10 Lb-Ft).

NOTE: If necessary, align the rear door window glass with the rear door window channel bracket.