Turbine Shaft Speed (TSS) Sensor

Turbine Shaft Speed (TSS) Sensor

Removal
1. Raise and support the vehicle.
2. Place a drain pan beneath the turbine shaft speed (TSS) sensor.





3. Remove the TSS sensor.
- Disconnect the TSS sensor electrical connector (white plastic).
- Remove the bolt.
- Inspect the TSS sensor bore.





4. Inspect the O-ring seal for nicks or cuts; install new as necessary.

Installation





1. NOTE: Apply a light coat of petroleum jelly to the O-ring seal before installation.

Install the TSS sensor.
- Connect the TSS electrical connector (white plastic).
2. Remove the drain pan.
3. Lower the vehicle.





4. Check the transmission fluid level, add automatic transmission fluid.





5. Start the engine and move the transaxle range selector lever through all gear positions.