Dual Converter Y-Pipe
Dual Converter Y-PipeRemoval
All vehicles
1. Raise and support the vehicle.
2. Disconnect the Catalyst Monitor Sensor (CMS).
1. Unclip the wiring harness.
2. Disconnect the CMS.
3. Remove the CMS.
4. NOTE: Manual transaxle vehicle shown, automatic similar.
Remove the catalytic converter left-hand flange nuts.
5. Remove the catalytic converter right-hand flange nuts.
Vehicles with manual transaxle
6. Remove the secondary catalytic converter inlet flange nuts.
Vehicles with automatic transaxle
7. Remove the flexible pipe inlet flange nuts.
- Remove the three nuts.
All vehicles
8. Remove the dual converter Y-pipe bracket nut.
9. Remove the dual converter Y-pipe.
Installation
All vehicles
1. To install, reverse the removal procedure.
Vehicles with automatic transaxle
Vehicles with manual transaxle
All vehicles