Ignition Cable: Service and Repair

"AllData Editors Note:

Customers have reported success using the following spark plug wire placement on the coil pack."

Spark Plug Wire Remover:

SPECIAL TOOL(S)

REMOVAL

CAUTION:
^ Spark plug wires must be connected to the correct ignition coil terminal.
^ It is important to twist the spark plug wire boots while pulling upward to avoid possible damage to the spark plug wire.

Spark Plug Wire Remover:

1. Using the special tool, with a twisting motion pull the spark plug wire off the spark plug.







2. Disconnect the spark plug wire from the ignition coil by twisting while pulling upward.
3. Open the spark plug wire separators and remove the spark plug wire.

INSTALLATION
1. To install, reverse the removal procedure.

CAUTION: Be sure to orient the spark plug boots so the spark plug wires do not contact the exhaust manifold.

NOTE: Apply Silicone Brake Caliper Grease and Dielectric Compound D7AZ-19A331-A or equivalent meeting Ford specification ESE-M1C171-A to the inside of spark plug and ignition coil boots of the spark plug wire.