FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.

Driver Side






SPECIAL TOOL(S)

REMOVAL
1. Prepare the vehicle for seat cushion removal.
1 Disconnect the battery ground cable and wait at least one minute.

WARNING:
^ TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE BACKUP POWER SUPPLY MUST BE DEPLETED BEFORE REPAIRING OR REPLACING ANY FRONT OR SIDE AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM (SRS) COMPONENTS AND BEFORE SERVICING, REPLACING, ADJUSTING OR STRIKING COMPONENTS NEAR THE FRONT OR SIDE AIR BAG SENSORS, SUCH AS DOORS, INSTRUMENT PANEL, CONSOLE, DOOR LATCHES, STRIKERS, SEATS AND HOOD LATCHES.
^ TO DETERMINE LOCATION OF THE FRONT AIR BAG SENSORS, REFER TO AIR BAG SYSTEMS.
^ THE SIDE AIR BAG SENSORS ARE LOCATED AT OR NEAR THE BASE OF THE B-PILLAR.
^ TO DEPLETE THE BACKUP POWER SUPPLY ENERGY, DISCONNECT THE BATTERY GROUND CABLE AND WAIT AT LEAST ONE MINUTE. BE SURE TO DISCONNECT AUXILIARY BATTERIES AND POWER SUPPLIES (IF EQUIPPED).


2 Deactivate the Supplemental Restraint System (SRS) and remove the driver seat.

WARNING: TO REDUCE THE RISK OF SERIOUS PERSONAL INJURY, READ AND FOLLOW ALL WARNINGS, CAUTIONS, NOTES AND INSTRUCTIONS IN THE SEAT REMOVAL AND INSTALLATION PROCEDURE.

NOTE: The supplemental restraint system (SRS) deactivation and reactivation has been incorporated as part of the seat removal and installation procedure.

2. Remove the seat backrest.
3. Remove the seat track.
4. Remove the seat cushion.

INSTALLATION
1. Install the seat cushion.
2. Install the seat track.
3. Install the seat backrest.
4. Restore the vehicle to operating condition.
1 Install the driver seat and reactivate the supplemental restraint system (SRS).

WARNING: TO REDUCE THE RISK OF SERIOUS PERSONAL INJURY, READ AND FOLLOW ALL WARNINGS, CAUTIONS, NOTES AND INSTRUCTIONS IN THE SEAT REMOVAL AND INSTALLATION PROCEDURE.

NOTE: The supplemental restraint system (SRS) deactivation and reactivation has been incorporated as part of the seat removal and installation procedure.

2 With all the restraint system diagnostic tools removed, prove out the supplemental restraint system (SRS).

WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE FROM THE VEHICLE PRIOR TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE VIOLATION OF THE VEHICLE SAFETY STANDARDS.

3 Check the active restraint system for correct operation.