Removal and Installation

Selector Lever

Removal

1. CAUTION: Disconnect the battery ground cable.

Raise the vehicle.
2. Remove the heat shield.





3. Disconnect the selector lever assembly.
1. Disconnect the selector cable adjusting cap.
2. Disconnect the selector cable.
3. Remove the nuts.
4. Lower the vehicle.
5. Remove the front ash receptacle and lighter element. Remove the lighter trim if equipped.





6. Remove the selector lever assembly.
1. Remove the cover.
2. Lift out the selector lever assembly.
3. Disconnect the selector lever electrical connector.

Installation





1. Install the selector lever assembly.
1. Reconnect the selector lever electrical connector.
2. Position the selector lever.
3. Install the cover.
2. Install the lighter trim, if equipped. Install the lighter element and the front ash receptacle.
3. Raise the vehicle.





4. Install the selector lever assembly.
1. Install the nuts.

NOTE: Do not lock the selector cable adjusting cap.

2. Connect the selector cable.
5. Install the heat shield.
6. Lower the vehicle.
7. Adjust the cable and selector lever.

8. NOTE: When the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive strategy.

Connect the battery ground cable.