Sensor, Rear

Removal
1. Loosen the wheel nuts.
2. Raise and support the vehicle.
3. Remove the wheel.





4. Remove the wheel sensor.





5. Disconnect the wheel sensor wiring from the support brackets and clips.
6. Lower the vehicle.





7. Raise the rear seat cushion.
1 Push the cushion towards the backrest.
2 Pull the cushion up.





8. Remove the screw.
^ Push the trim to one side.





9. Disconnect the wheel sensor electrical connector.
^ Pull the cable through the grommet.

Installation





1. To install, reverse the removal procedure.