Brake Fluid Reservoir

Removal





1. CAUTION: If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water.

NOTE: Make sure the filler cap does not become contaminated.

Remove the reservoir filler cap.
1 Disconnect the electrical connector.
2 Remove the cap.





2. Using a suitable suction device drain the reservoir.

Vehicles with manual transaxle





3. Disconnect the clutch master cylinder feed hose.

All vehicles





4. Remove the brake fluid reservoir.
^ Detach the two retaining clips.
5. Remove and discard the O-ring seals.

Installation

NOTE: After installation, bleed the brake system.

1. NOTE: Install new O-ring seals.

To install, reverse the removal procedure.