| Head gasket surface overall flatness | | 0.076 Millimeter (mm) |
| Head gasket surface finish roughness height | | 3.8 - 2.0 Millimeter (mm) |
| Head gasket surface finish roughness height cutoff | | 0.8 Millimeter (mm) |
| Dowel height chamfer Total | | 0.800 x 12.5 mm |
| Piston to cylinder bore clearance | | 0.020 - 0.040 mm |
| Surface finish (RA) each bore min | | 15 - 38 |
| Average of all bores of a cylinder block RA min. | | 20 - 30 |
| Out of round limit | | 0.025 Millimeter (mm) |
| Taper limit | | 62.2835 - 62.3145 Millimeter (mm) |
| Main bearing bore diameter @ +/- 30 degrees PF bearing cap P/L | | 62.2935 +/- 0.0100 Millimeter (mm) |
| Cylinder bore dia. | class 1 | 84.800 - 84.810 Millimeter (mm) |
| class 2 | 84.810 - 84.820 Millimeter (mm) |
| class 3 | 84.820 - 84.830 Millimeter (mm) |
| Lower Crankcase To Cylinder Block | | 22 Foot Pound-Force (ft.lb) |
| Number of main bearings | | 5 |
| Inside dia. - main bearing shells (fitted) | | 58.011 - 58.038 Millimeter (mm) |
| Inside dia. - main bearing shells (fitted) (main bearing shells graded by size) | | 58.008 - 58.031 Millimeter (mm) |
| Main bearing radial clearances | | 0.011 - 0.058 mm |
| Main bearing radial clearances (main bearing shells graded by size) | | 0.0196 - 0.044 mm |
| Main bearing parent bore | | 62.287 - 62.300 mm |
| Blanking Plugs, Cylinder Block Oil Channels | | 18 Foot Pound-Force (ft.lb) |
| Crankcase Ventilation Tube To Cylinder Block | | 89 Inch Pound-Force (in.lb) |
| Crankcase Ventilation To Cylinder Block | | 89 Inch Pound-Force (in.lb) |