Keyless Entry Transmitter: Testing and Inspection

PROGRAMMING


NOTE:
^ A maximum of four keyless entry remote transmitters can be programmed for each central locking/anti-theft module.
^ Upon program mode 3 entrance, once a transmitter button is pressed for the first time, the receiver module erases ALL previously stored transmitter codes in the memory. All transmitters must be present at the same time to be programmed to the vehicle.
^ To enter programming mode, first verify that the battery is fully charged.

1. Turn the ignition switch to RUN.
2. Locate the programming connector and momentarily short the 2 pins. The shorting bar connector is located near the control module. The horn will bleep to confirm program mode entrance.
3. Press any button on a remote entry transmitter. The horn will bleep to acknowledge the transmitter code was received.
4. Repeat Step 3 for any additional remote entry transmitters wished to be programmed to the vehicle.
5. Turn the ignition switch OFF to exit program mode. To confirm the program mode has been exited the horn will bleep one last time.