| Head Gasket Surface Overall Flatness | 0.076 Millimeter (mm) |
| Head Gasket Surface Finish Roughness Height (CLA) | 3.8 - 2.0 Millimeter (mm) |
| Head Gasket Surface Finish Roughness Height Cutoff | 0.8 Millimeter (mm) |
| Dowel Height Chamfer mm | 0.8 x 30 Degrees |
| Total | 12.5 Millimeter (mm) |
| Piston To Cylinder Bore Clearance | 0.020 - 0.040 mm |
| Surface Finish (RA) Each Bore Min. | 15 - 38 |
| Average Of All Bores Of A Cylinder Block (RA) Min. | 20 - 30 |
| Out Of Round Limit | 0.025 Millimeter (mm) |
| Taper Limit | 0.013 Millimeter (mm) |
| Main Bearing Bore Diameter @ +/- 30 Degrees PF Bearing Cap P/L | 62.2835 - 62.3145 Millimeter (mm) |
| Other Than Above | 62.2935 +/- 0.0100 Millimeter (mm) |
| Cylinder Bore Diameter, Class 1 | 84.800 - 84.810 Millimeter (mm) |
| Cylinder Bore Diameter, Class 2 | 84.810 - 84.820 Millimeter (mm) |
| Cylinder Bore Diameter, Class 3 | 84.820 - 84.830 Millimeter (mm) |
| Lower Crankcase To Cylinder Block | 22 Foot Pound-Force (ft.lb) |
| Lower Crankcase To Upper Crankcase Bolts | 16 Foot Pound-Force (ft.lb) |
| Lower Crankcase To Transmission Bolts | 30 Foot Pound-Force (ft.lb) |
| Crankcase Ventilation Tube To Cylinder Block | 89 Inch Pound-Force (in.lb) |
| Crankcase Ventilation To Cylinder Block | 89 Inch Pound-Force (in.lb) |
| Blanking Plugs, Cylinder Block Oil Channels | 18 Foot Pound-Force (ft.lb) |