Extension Housing: Service and Repair

Removal

1. Note: Take care not to damage the flywheel housing to block dowel holes or the surface areas around the flywheel housing to block dowel hole during removal.

Remove the flywheel housing to block dowels using a drift pin where the flywheel housing to block dowel is installed in an open hole and a pair of locking pliers where the flywheel housing to block dowel is installed in a blind hole.

Installation

1. Note: Care should be taken to drive the flywheel housing to block dowel squarely into place until it is fully seated without damaging the surrounding surface areas.

Install all flywheel housing to block dowels by driving them into place using a brass or plastic mallet.