Disassembly and Assembly
Disassembly1. Remove transaxle range selector lever and housing.
2. Remove two shift indicator bulbs from transmission control selector dial bezel and remove shift indicator illumination wiring from transaxle range selector lever housing.
3. Unsnap and slide transaxle range selector lever bezel sleeve to expose transaxle range selector lever knob retaining screws.
4. Remove two transaxle range selector lever knob retaining screws.
5. CAUTION: Do not twist knob or plastic upper rod, damage could occur.
Push in on transaxle range selector lever knob button and carefully lift transaxle range selector lever off transaxle range selector lever.
6. If equipped, disconnect transaxle range selector lever knob wire connector.
7. Remove transaxle range selector lever bezel sleeve from transaxle range selector lever.
8. Unsnap and remove transmission control selector dial bezel from transaxle range selector lever housing.
Assembly
1. Install transmission control selector dial bezel onto transaxle range selector lever housing and secure with four retainer clips.
2. Install transaxle range selector lever bezel sleeve onto transaxle range selector lever.
3. Push in on transaxle range selector lever knob button and carefully install transaxle range selector lever knob onto transaxle range selector lever while aligning transmission control switch connector.
4. If equipped, connect transaxle range selector lever knob wire connector.
5. Install two transaxle range selector lever knob retaining screws.
6. Slide transaxle range selector lever bezel sleeve up and secure into position.
7. Install two shift indicator bulbs into transmission control selector dial bezel and route shift indicator illumination wiring behind transaxle range selector lever housing connector.
8. Install transaxle range selector lever and housing.
9. Adjust transmission shift control linkage.
10. Check transmission control switch for proper operation. O/D OFF indicator on instrument cluster should indicate switch function.