60 (RH) Rear With Integrated Child Seat

REMOVAL
1. Remove seat back assembly from vehicle and place it on a clean surface.
2. Disengage J-retainer and pushpins at bottom of seat back.
3. Remove staples from back panel carpet tie down.
4. Remove pivot bolts from child seat cushion.
5. Remove shoulder belt bezels from frame and belts.
6. Remove pushpins below bezels and disengage trim wires.
7. Remove rear seat back cover from assembly.
8. With child seat cushion pan removed, disengage J-retainer at cushion bottom and behind child seat back flex-mat.
9. Remove trim cover.

INSTALLATION
1. Position rear seat back cover evenly to seat back frame assembly.
2. Feed shoulder belts through holes in cover and bezels.

CAUTION: Failure to properly place belts in belt guides could result in loss of belt function.

3. Position rear seat back pad and rear seat back cover and install bezel.
4. Install J-retainers pushpins and trim wires to attach trim cover.
5. Install child seat pivot bolt to attach cushion pan and belt anchors. Tighten pivot bolts to 9-15 Nm (7-11 lb-ft).
6. Check the restraint system for proper operation.