With Manufacturer's Scan Tool (NGS Tester)

NOTE: For detailed instructions and other diagnostic methods using the NGS, refer to Powertrain Management or NGS instruction guide.

NOTE: If using a generic scan tool, refer to Powertrain Management for instructions on performing OBD procedures.

The Quick Tests are in Powertrain Management. These tests can be used to diagnose the Powertrain control module, sensors, and actuators of the CD4E transaxle.

The following is a guide for using the on-board diagnostic (OBD) Quick Tests and the New Generation STAR (NGS) Tester.
- Quick Test 1.0 - Visual Inspection
- Quick Test 2.0 - Set Up
- Quick Test 3.0 - Key On, Engine Off
- Quick Test 4.0 - Continuous Memory
- Quick Test 5.0 - Key On, Engine Running
- Special Test Mode
- Wiggle Test Mode - Output Test Mode
- PCM Reset Mode
- Clearing DTCs
- OBD II Drive Cycle
- Other NGS Features