Inspection and Verification (Start Testing Here)

1. Verify the customer concern by operating the system.
2. Visually inspect for obvious signs of electrical damage.

VISUAL INSPECTION CHART

Electrical
^ Fuse
^ Loose or corroded connector(s)
^ Circuit
^ Switch(yes)
^ Relay
^ Resistor
^ Diode(s)

3. If an obvious concern for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
4. If the concern is not visually evident, verify the symptom and refer to the Symptom Chart. Symptom Related Diagnostic Procedures