Multi-Function Switch Housing

REMOVAL
1. Remove the air bag sliding contact.





2. Remove the screws and the upper and lower steering column shrouds.





3. Remove the turn signal switch.
1 Detach the electrical connector from the turn signal switch.
2 Remove the screws.
3 Disconnect the electrical connectors.
4 Remove the turn signal switch.





4. Remove the windshield wiper/washer switch.
1 Remove the screws.
2 Disconnect the electrical connectors.
3 Remove the windshield wiper/washer switch.





5. Detach the hazard/flasher switch from the multi-function switch housing.





6. Disconnect the electrical connector.





7. Remove the multi-function switch housing.
1 Remove the screws.
2 Remove the multi-function switch housing.

INSTALLATION











1. To install, reverse the removal procedure.

NOTE: After the multi-function switch housing is installed, check the sliding contact adjustment.