Pressure Hose

REMOVAL
1. Open hood.
2. Disconnect battery ground cable.
3. Drain and remove radiator coolant recovery reservoir.
4. Drain and remove power steering pump reservoir.
5. Remove drive belt.
6. Using Steering Pump Pulley Remover 211-016, remove power steering pump pulley from power steering pump.
7. Disconnect pressure line mounting bracket from engine assembly.
8. Disconnect power steering left turn pressure hose from power steering pump fitting.
9. Disconnect electrical connector from Power Steering Pressure Switch (PSP Switch).
10. Disconnect pressure line mounting bracket at top of steering shaft u-joint shield.
11. Disconnect power steering left turn pressure hose from power steering rack fitting and remove power steering left turn pressure hose from vehicle.

INSTALLATION
1. Follow removal procedure in reverse order.
2. Use Steering Pump Pulley Replacer 211-009 to install power steering pump pulley. Install new O-rings on power steering left turn pressure hose.
3. Fill and bleed power steering system with Motorcraft MERCON Multi-Purpose (ATF) Transmission Fluid XT-2-QDX or equivalent meeting Ford MERCON specification. Check system for leaks and proper operation.