Headlamp Switch: Service and Repair

REMOVAL
1. Disconnect battery ground cable.
2. Turn headlamp switch knob to the headlamp ON position and pull the knob out.
3. Insert a thin tool into the slot at the base of the knob to release it and pull the headlamp switch knob off.
4. Position the knob with the back end toward the headlamp ON position and install.
5. Turn the knob counterclockwise until the back of the knob is in the OFF position.
6. Turn the headlamp switch knob clockwise fully, remove the headlamp switch from the instrument panel and disconnect the electrical connectors.

INSTALLATION

NOTE: When installing a new replacement switch, connect the electrical connectors and snap the switch into the instrument panel.

1. Follow removal procedure in reverse order when installing the original switch.