Installation

1. Position cooling fan motor, fan blade and fan shroud assembly into vehicle.





2. Install four bolts through cooling fan motor, fan blade and fan shroud assembly brackets into front end frame rails. Tighten to 20-30 N m (15-22 ft. lbs.).
3. Connect power steering fluid cooler to power steering pump.
4. Install six screws into engine control sensor wiring. Tighten securely.
5. Connect engine control sensor wiring to power steering pump.
6. Install four bolts to power distribution box and harness and bracket assembly. Tighten to 25-35 Nm (18-25 ft. lbs.).
7. Connect upper radiator hose and radiator overflow hose to radiator.
8. Install upper radiator support.
9. Install front bumper cover.
10. Install four bolts into hood latch support assembly. Tighten to 25-35 Nm (18-25 ft. lbs.).
11. Raise vehicle.
12. Install both transmission oil cooler tubes to the left end of power steering/transmission cooler. Tighten clamps securely.
13. Install power steering transmission cooler and secure with one bolt and one nut. Tighten to 5-7 N m (45-61 inch. lbs.).
14. Connect lower transmission oil cooler tube to radiator cap.
15. Connect A/C evaporator muffler and hoses to A/C condenser core.
16. Connect lower radiator hose to radiator and clamp securely.
17. Install four bolts to lower radiator hose shield and tighten to 5-7 Nm (45-61 inch. lbs.).
18. Lower vehicle.
19. Install battery tray.
20. Install battery.
21. Install engine air cleaner.
22. Fill power steering reservoir and bleed.
23. Fill and bleed engine cooling system.
24. Charge air conditioning system.