Rear

REMOVAL
1. Raise vehicle on hoist.





2. Disconnect rear brake anti-lock sensor from the mating body connector located under the vehicle in the center on No.4 crossmember as shown.
3. Disconnect routing clips from rear suspension arm and bushing and No.4 crossmember torque box.
4. On station wagon, remove retaining bolt and rear brake anti-lock sensor from rear disc brake adapter on sedan and from rear wheel spindle.

INSTALLATION
1. Insert rear brake anti-lock sensor into hole in rear disc brake adapter on sedan, and into hole in rear wheel spindle on station wagon. Install retaining bolt. Tighten to 7.6 - 10.4 Nm (68 - 92 inch lbs.).
2. Install sensor routing clips to rear suspension arm and bushing and No.4 crossmember torque box.





3. Connect rear brake anti-lock sensor to mating body connector as shown.
4. Lower vehicle.