Speaker Walk-Around Test

Included in the audio system on-board diagnostic capabilities is the SPEAKER WALK-AROUND test. This test will automatically adjust the volume to mid-level and display SPKR on the front control unit. The fade and balance will then select each speaker as follows: right front, left front, right rear, left rear.

To enter this test while in the diagnostic mode, press pre-set button 2.

To enter this test when not in diagnostic mode, press and hold memory presets 3 and 6 simultaneously and release when SPKR is displayed. In this mode, two additional self test messages could be displayed:
- NO DJ will be displayed if no CD player is detected and the installed radio chassis is expecting a CD player.
- BAD BUILD will be displayed if there is a mis-match between the rear chassis unit (digital or analog) and the integrated control panel.

Pressing any button during speaker walk-around test will abort this test.

The system will then exit the test automatically upon completion of the test.