Quick Test 2.0 - Set Up

Connect the New Generation STAR (NGS) tester to Data Link Connector (DLC). The following are procedures to run OBD II procedures:

VEHICLE AND TESTER PREPARATION
Prepare the vehicle as follows:
- Place transaxle range selector lever in PARK.
- Warm the engine to operating temperature.
- Apply the parking brake.
- Block the wheels.
- Turn off all electrical loads including A/C and defroster. (If A/C is on, DTC P1460 will set.)

Part 1 Of 2:

Part 2 Of 2:

NEW GENERATION STAR (NGS) TESTER
Prepare the New Generation STAR (NGS) tester as follows:
- Turn ignition switch to the OFF position.
- Verify that the proper Program card is inserted in the New Generation Star (NGS).
- Connect J1962/16 way DLC cable adapter to the NGS.
- Connect NGS DLC cable adapter securely into the vehicle DLC connector.
- Connect the NGS power supply cable to the vehicle battery power supply through the cigarette lighter or at the battery with alligator clip adapter.
- Turn the ignition switch to the RUN position, or start vehicle, if necessary.
- The NGS is now ready to communicate with the Powertrain Control Module (PCM).