Assembly

1. Assemble the selector lever.
1 Put the spring in place.
2 Insert the plunger.
3 Slide on the sleeve and compress it.
4 Pretension the spring using a screwdriver.
- Pull the plunger back slightly.





2. Fit the sleeve.
1 Position the sleeve.
2 Drive in the retaining pin and align it centrally.





3. Fit the selector lever.
1 Position the selector lever into the transmission.

NOTE: Bring the locating tooth into engagement.

2 Drive in the pivot pin.





4. Position the upper part of the body and the solenoid switch.
1 Install the upper body bolts.
2 Hook the plunger of the solenoid switch onto the lever.
3 Install the solenoid switch bolts.





5. Position the detent spring and adjust the selector lever.
- Move the selector lever to position "D".
1. Install the detent spring loosely.
2. Position feeler gauge.
3. Tighten the detent spring.
- Check the gap again after moving the selector lever several times.





6. Install the park position switch.





7. Install the cover.
1 Insert the lamp.
2 Position cover.





8. Install the selector lever knob.
1 Using cable installed during disassembly, guide the cable in and insert the O/D switch.
- Push the selector lever knob on the selector lever.

CAUTION: Do not damage the O/D cable when pushing it on.

- Carefully route the cable.
2 Install the screw.





9. Connect the electrical connector.
1 Violet White
2 Black White
3 Yellow/Orange
4 Yellow/Orange
5 Orange/Black
6 Black
7 Black/Green
8 Black/Green
- Insert the cable retainer.
- Fit the connector.