No-Load Test

1. Connect 88 Digital Multimeter to monitor engine speed.
2. Connect 73 Digital Multimeter leads across the battery terminals.
3. Read the voltage (base voltage).
4. Start the engine.
5. Run the engine to 1500 rpm with no electrical load.
6. Read the voltage. The voltage should be in the range of 14.1 to 14.7 volts. If the voltage increase is less than 2.5 volts over the base voltage, perform the Load Test. Load Test
If there is no voltage increase or the voltage increase is greater than 2.5 volt, perform the generator on-vehicle test. Generator On-Vehicle Tests