Rear Washer Pump and Reservoir

REMOVAL







1. Disconnect the battery ground cable.







2. Remove the four push pins and the RH quarter trim panel.







3. Remove the three bolts.
4. Pull the rear window washer reservoir straight up and remove.







5. Disconnect the rear window washer pump electrical connector and hose.
6. Drain the rear window washer reservoir into a suitable, clean container so that the washer solvent can be reused.







7. Pry the rear window washer pump from the rear window washer reservoir.
8. Remove the rear window washer pump to reservoir seal and discard if it shows any signs of wear.







INSTALLATION
1. To install, reverse the removal procedure.