Connecting Rod

Alignment, Bore to Bore (Maximum Differential)
Twist 0.050 mm (0.0020 inch)
Bend 0.038 mm (0.0015 inch)
Bearing Bore
Diameter 46.89-46.91 mm (1.8460-1.8468 inch)
Out of Round 0.010 mm (0.0004 inch)
Taper, Maximum 0.010 mm (0.0004 inch)
Clearance, Side
Nominal 0.092-0.268 mm (0.004-0.011 inch)
Limit 0.356 mm (0.014 inch)
Clearance of Crankshaft
Without Cylinder Head
Desired 0.0457-0.0660 mm (0.0018-0.0026 inch)
Allowable 0.0461-0.0859 mm (0.0018-0.0034 inch)
With Cylinder Head
Desired 0.0279-0.0483 mm (0.0011-0.0019 inch)
Allowable 0.0276-0.0674 mm (0.0011-0.0027 inch)
Length (Center to Center) 131.905-131.975 mm (5.193-5.196 inch)
Piston Pin Bore
Diameter 20.570-20.610 mm (0.8098-0.8114 inch)
Out of Round, Maximum 0.008 mm (0.0003 inch)
Taper, Maximum 0.0038 mm per 25.4 mm
0.00015 inch per 1 inch

Tightening Specifications
* Bearing Cap 35-41 Nm (26-30 ft. lbs.)

* Tighten the connecting rod nuts to specification. Back off two or three turns and retighten to specification.